Plastic bearing bushing is one of the more important parts in the transmission equipment, not only by friction, tension and inertia force and other mechanical stress, but also by some lubricants, lubricating additives or its aging products, organic solvents or coolants produced by chemical effects.
In the daily operation and production of food industry enterprises, in order to better use plastic bearing seat, it is necessary to carry out regular maintenance and cleaning of plastic bearing seat. In the maintenance and cleaning of the plastic bearing seat, there are a lot of places to pay attention to, and not take some cleaning agent can be cleaned casually, bad will also cause damage to the plastic bearing seat in cleaning, so the correct maintenance and cleaning is also very necessary.
HARM OF Plastic bearing seat does not maintain
1, once you do not pay attention to the maintenance of plastic bearing seat, it will cause the destruction of the long-term accumulation of dust on the plastic bearing seat. These accumulated dust will make food belt production line accessories plastic bearing seat lubrication performance affected,
2. Do not pay attention to the maintenance of plastic bearing seat, easy to make the formation of lubricating oil film on the surface of plastic bearing seat, and then the deterioration of grease leads to deterioration and acceleration of the aging of plastic bearing seat.
3. The vibration level of the plastic bearing seat is affected by the cleanliness of the plastic bearing seat, especially the vibration of the high frequency band of the food belt production line is more obvious. Lead to food belt production line accessories plastic bearing seat noise increase, seriously affect the production environment of production enterprises.
Plastic bearing maintenance methods
1. After the operation of the plastic bearing seat in the production and transportation operation of food enterprises, the power supply of the food conveying equipment should be turned off to avoid unnecessary accidents.
2. When the bearing is removed for detection, the appearance should be recorded by means of photography first.
3. In addition, it is necessary to confirm the amount of remaining lubricant and sample lubricant, and then clean the bearing.
4. Cleaning and maintenance of plastic bearing seat are divided into rough washing and fine washing, and metal mesh can be placed at the bottom of the container in use.
5, rough washing, in the top of the oil with a brush to remove grease or adhesion.
6. At this time, if the bearing is transferred in the oil, the rolling surface is damaged by foreign bodies. Fine washing, slowly transfer in the oil to change the bearing, must vigorously stop.
7, daily use of cleaning agent for neutral water-free diesel or oil, according to demand sometimes also use temperature lye.
8, no matter what kind of cleaning agent is used, it is necessary to constantly filter and clean. After cleaning, immediately coat the bearing with anti-rust oil or anti-rust grease.
